Outdoor Sofa Cover - 190cm / 2 to 3 Seater - Australian Made

• Suitable for Patio Chairs, Sofas or Bench Seats that measure up to 190cm Long x 85cm Deep x 85cm High Back (55cm High Armrest)
• Actual cover is 195cm Long x 90cm Deep
• Available in Dark Grey and Black
• Highly Water Resistant Fabric with PU coating on the inside
• Comes with Tie Down Strap with side release buckle and built-in air vent to assist ventilation and reduce moisture trapping

Our Australian Made premium SD range of outdoor covers are ready made and suited to many popular furniture sizes. There are no special fitting instructions for this cover - just lift the cover over your item and pull down the sides, utilising the straps for a neat finish. It is very easy to install.

Sofa or Bench Seat Covers are designed for furniture where the armrests finish lower than the backrest.

How to Measure Your Furniture for a Cover
When measuring your Furniture, be sure to measure the size of your actual furniture. The following information is a guide for how to choose the best size cover.

Almost all furniture covers are supplied with Side Release Buckles to allow you to secure them tightly onto the furniture that you are covering. If the size of your furniture is smaller than the cover, you should still able to get a good fit by adjusting these features.

Most of our covers have an extra 5cm / 50mm length than the size they are designed to fit - please see each cover's description for details. As an example, if your furniture is 240cm long and the cover length is 240cm long too, then this cover is likely to fit appropriately as there is the 5cm allowance in the cover design for fitment. If you furniture measurement is, for example, 220cm and the closest cover size is 240cm length, then this cover can still be used because of the elasticated hem and the available securing straps.

Also if the actual length of your furniture is 230cm and your width is 110cm, and the cover size is listed as 240cm length with 100cm depth, this cover may still be suitable because your length has an excess of 10cm which should accommodate the wider width your furniture needs - it just means that your seams will not sit flush on the corners, but instead just a little off the corner line.